Wisefab Front Drift Angle Lock Kit, BMW E30 3 Series (WF030)

Bolt-on front angle kit for the E30 with over 60 degrees of lock and light but strong control arms. Set toe and go.

Fits

• BMW 3 Series (E30): Requires E36 inner tie rods; Wisefab does not address the AWD 325iX

Before you order

• Requires BMW E36 inner tie rods (Wisefab recommends new ones).
• Coilovers required. Wider fenders or flares are needed with this kit.
• Wisefab recommends tire diameter no larger than 620 mm (235/40R17).
• The kit bolts hub add-ons to the factory uprights: their bottom faces must be flat and clean of rust, so machine down any high spots or hammer damage before fitting.

Highlights

• Over 60 degrees of lock
• Bolt-on install
• Raised front roll centre on a lowered car, so the front anti-roll bar can be removed for maximum usable lock
• Revised Ackermann: corrects the factory tendency for the inside wheel to turn more, which costs speed and grip when drifting
• Geometry minimises positive camber on the leading wheel at high angles and controls steering jacking
• Self-aligning behaviour tuned so the wheel does not lock up at full lock

In the kit

• Adjustable coilover top mounts (Formula Drift compliant)
• Hub add-ons with hardware
• Lightweight lower control arms
• Assembled tie rods
• Adjustable lower control arm rear mounts
• Installation guide