




Wisefab
Wisefab Front Drift Angle Lock Kit, BMW E90 / E92 / M3 and E8x 1 Series / 1M (WF900)
$3,364.39
Taxes and shipping shown at checkout. Typical delivery is 3 to 7 business days across Canada.
✓ Confirmed-fit parts — add your vehicle in your Garage to check fitment.
Front angle kit for the E9x 3 Series and E8x 1 Series, including the M cars. Brackets for the M brake caliper are included, and the Wisefab knuckle works with either M or non-M front coilovers.
Fits
- BMW 3 Series (E90)
- BMW 3 Series (E91)
- BMW 3 Series (E92)
- BMW 1 Series (E81)
- BMW 1 Series (E82)
- BMW 1 Series (E87)
- BMW 1 Series (E88)
- BMW M3 (E90)
- BMW M3 (E92)
- BMW 1M (E82): Listed by Wisefab as 'E82 M'
Before you order
- The original ABS wheel speed sensor can be reused.
- Coilovers required (M or non-M front coilovers both work). Designed for a ride height of about 80 mm from the front subframe to the ground.
- Depending on wheel width and offset, wider fenders or flares will be needed. No inner wheel well trimming needed with tires up to about 635 mm diameter (for example 215/45R17, 235/40R17, 225/40R18).
- Minimum wheel size 17 in (some 17 in wheels will not fit). Recommended backspacing about 135 mm (7 in ET45, 8 in ET35, 9 in ET20). Wisefab quotes the front track at 90 mm wider per side than factory.
- This is the standard-width kit; Wisefab also makes a narrow E9x version.
Highlights
- 65 degrees of lock with parallel steering
- Ackermann is adjustable toward positive or negative in a few minutes at the track without upsetting the alignment (adjustment hardware included).
- Adjustable lock stopper
- One-piece lower control arm replaces the factory links (tension rods no longer needed); caster adjusts at the arm
- Dropped joints raise the front roll centre, so the front anti-roll bar can be removed
- Geometry is tuned for dynamic camber, low bump steer and controlled steering jacking across the full steering range, so the wheel self-centres instead of sticking at full lock.
- High-strength steel throughout. Rod ends and spherical bearings throughout, no rubber bushings.
In the kit
- Adjustable coilover top mounts (Formula Drift compliant)
- Knuckles with hardware
- Lower control arms
- Assembled tie rods
- Brake adapters for M brakes
- 45 mm coilover adapter sleeve
- Installation guide
Related parts
More for your 1 Series →Parts that pair with this one on your 1 Series.







